Material determines chemical compatibility Standard durometer is 70 Shore A
Wrong material = catastrophic seal failure
PRODUCT OVERVIEW
The HANDLE,DOOR is a the manufacturer industrial component. Key specifications include material: STEEL OVERALL, shaft_length: 2.000 INCHES NOMINAL IN, pinhole_diameter: 0.093 INCHES MINIMUM AND 0.094 INCHES MAXIMUM IN, surface_treatment: ENAMEL SEMIGLOSS HANDLE, square_shaft_width: 0.312 INCHES MINIMUM AND 0.315 INCHES MAXIMUM IN, integral_shaft_style: SQUARE W/PIN HOLE. This part is cataloged in the Federal Logistics Information System (FLIS) under NSN 5340-00-734-9092, indicating validated use in U.S.
government and defense logistics supply chains. Available through authorized enterprise resellers and TPM (Third Party Maintenance) channels. Verify compatibility with your specific system configuration before ordering.
WHERE IT FITS
T1-165-8
NSN:5340-00-734-9092 FSC:5340 CAGE:99063 — TRANSPORTATION CONSTRUCTION CORP (USA)
SPECIFICATIONS
material
STEEL OVERALL
shaft_length
2.000 INCHES NOMINAL IN
pinhole_diameter
0.093 INCHES MINIMUM AND 0.094 INCHES MAXIMUM IN
surface_treatment
ENAMEL SEMIGLOSS HANDLE
square_shaft_width
0.312 INCHES MINIMUM AND 0.315 INCHES MAXIMUM IN
integral_shaft_style
SQUARE W/PIN HOLE
length_from_pinhole_center_to_end
0.250 INCHES NOMINAL IN
material_document_and_classification
QQ-S-633,FS1010 TO FS1020 FED SPEC SINGLE MATERIAL RESPONSE OVERALL
surface_treatment_document_and_classification
TT-E-485 FED SPEC SINGLE TREATMENT RESPONSE OVERALL
NSN
5340-00-734-9092
COMPONENT DIAGRAM
KEY FEATURES
•
SQUARE SHAFT WIDTH: 0.312 INCHES MINIMUM AND 0.315 INCHES MAXIMUM IN
•
LENGTH FROM PINHOLE CENTER TO END: 0.250 INCHES NOMINAL IN
•
MATERIAL DOCUMENT AND CLASSIFICATION: QQ-S-633,FS1010 TO FS1020 FED SPEC SINGLE MATERIAL RESPONSE OVERALL
•
SURFACE TREATMENT: ENAMEL SEMIGLOSS HANDLE
•
SURFACE TREATMENT DOCUMENT AND CLASSIFICATION: TT-E-485 FED SPEC SINGLE TREATMENT RESPONSE OVERALL
•
PINHOLE DIAMETER: 0.093 INCHES MINIMUM AND 0.094 INCHES MAXIMUM IN
•
SHAFT LENGTH: 2.000 INCHES NOMINAL IN
•
INTEGRAL SHAFT STYLE: SQUARE W/PIN HOLE
TECHNICAL CHARACTERISTICS (FLIS)
SQUARE SHAFT WIDTH
0.312 INCHES MINIMUM AND 0.315 INCHES MAXIMUM IN
LENGTH FROM PINHOLE CENTER TO END
0.250 INCHES NOMINAL IN
MATERIAL DOCUMENT AND CLASSIFICATION
QQ-S-633,FS1010 TO FS1020 FED SPEC SINGLE MATERIAL RESPONSE OVERALL
SURFACE TREATMENT
ENAMEL SEMIGLOSS HANDLE
SURFACE TREATMENT DOCUMENT AND CLASSIFICATION
TT-E-485 FED SPEC SINGLE TREATMENT RESPONSE OVERALL