RESISTOR,VARIABLE,WIRE WOUND,NON. Key specifications include end_type: COMPRESSION RING AND NUT SINGLE END, material: STEEL, body_style: RECTANGULAR W/MOUNTING HOLES/SLOTS, body_width: 0.275 INCHES NOMINAL IN, body_height: 0.312 INCHES NOMINAL IN, body_length: 1.250 INCHES NOMINAL IN. This part is cataloged in the Federal Logistics Information System (FLIS) under NSN 5905-00-068-5919, indicating validated use in U.S.
government and defense logistics supply chains. Available through authorized enterprise resellers and TPM (Third Party Maintenance) channels. Verify compatibility with your specific system configuration before ordering.
| end_type | COMPRESSION RING AND NUT SINGLE END |
| material | STEEL |
| body_style | RECTANGULAR W/MOUNTING HOLES/SLOTS |
| body_width | 0.275 INCHES NOMINAL IN |
| body_height | 0.312 INCHES NOMINAL IN |
| body_length | 1.250 INCHES NOMINAL IN |
| shaft_style | ROUND, SLOTTED |
| shaft_length | 0.050 INCHES NOMINAL IN |
| actuator_type | SINGLE SHAFT |
| shaft_diameter | 0.115 INCHES NOMINAL IN |
| mounting_method | UNTHREADED HOLE(S) |
| terminal_length | 0.500 INCHES NOMINAL IN |
| NSN | 5905-00-068-5919 |
| LATERAL DISTANCE BETWEEN MOUNTING HOLE CENTERS | 1.000 INCHES NOMINAL IN |
| BODY HEIGHT | 0.312 INCHES NOMINAL IN |
| ELECTRICAL RESISTANCE PER SECTION | 2.000 KILOHMS SINGLE SECTION |
| CENTER TO CENTER DISTANCE BETWEEN TERMINAL ROWS | 0.100 INCHES NOMINAL IN |
| POWER DISSIPATION RATING PER SECTION IN WATTS | 0.7 FREE AIR SINGLE SECTION |
| TERMINAL TYPE AND QUANTITY | 3 PIN |
| TERMINAL LOCATION | LOWER ADJACENT SIDE TWO ROWS LOCATION NOT OTHERWISE SPECIFIED |
| MOUNTING METHOD | UNTHREADED HOLE(S) |
| CENTER TO CENTER DISTANCE BETWEEN CENTER TERMINAL AND OUTSIDE TERMINAL | 0.300 INCHES NOMINAL IN |
| RESISTANCE TOLERANCE PER SECTION IN PERCENT | -5.0 TO 5.0 SINGLE SECTION |