RESISTOR,VARIABLE,NONWIRE WOUND,. Key specifications include body_style: CYLINDRICAL BUSHING MOUNTED, body_length: 0.453 INCHES NOMINAL IN, shaft_style: ROUND, SLOTTED, shaft_length: 0.625 INCHES NOMINAL IN, actuator_type: SINGLE SHAFT, body_diameter: 0.500 INCHES NOMINAL IN. This part is cataloged in the Federal Logistics Information System (FLIS) under NSN 5905-01-092-9681, indicating validated use in U.S.
government and defense logistics supply chains. Available through authorized enterprise resellers and TPM (Third Party Maintenance) channels. Verify compatibility with your specific system configuration before ordering.
| body_style | CYLINDRICAL BUSHING MOUNTED |
| body_length | 0.453 INCHES NOMINAL IN |
| shaft_style | ROUND, SLOTTED |
| shaft_length | 0.625 INCHES NOMINAL IN |
| actuator_type | SINGLE SHAFT |
| body_diameter | 0.500 INCHES NOMINAL IN |
| shaft_diameter | 0.125 INCHES NOMINAL IN |
| mounting_method | STANDARD BUSHING |
| section_quantity | 1 |
| terminal_location | REAR END |
| device_design_type | NONTURN AT 10:30 OCLOCKUNABLE TO DECODE |
| nonturn_device_radius | 0.245 INCHES NOMINAL IN |
| NSN | 5905-01-092-9681 |
| RELIABILITY INDICATOR | NOT ESTABLISHED |
| SHAFT LENGTH | 0.625 INCHES NOMINAL IN |
| BODY LENGTH | 0.453 INCHES NOMINAL IN |
| ACTUATOR TRAVEL CONTROL FEATURE | STOPS |
| AMBIENT TEMP IN DEG CELSIUS PER SECTION AT FULL RATED POWER | 70.0 SINGLE SECTION |
| TERMINAL TYPE AND QUANTITY | 3 TAB, SOLDER LUG |
| SPECIFICATION/STANDARD DATA | 81349-MIL-R-94/3 GOVERNMENT SPECIFICATION |
| RESISTANCE TOLERANCE PER SECTION IN PERCENT | -10.0 TO 10.0 SINGLE SECTION |
| POWER DISSIPATION RATING PER SECTION IN WATTS | 0.5 FREE AIR SINGLE SECTION |
| TEST DATA DOCUMENT | 81349-MIL-R-94 SPECIFICATION (INCLUDES ENGINEERING TYPE BULLETINS, BROCHURES,ETC., THAT REFLECT SPECIFICATION TYPE DATA IN SPECIFICATION FORMAT; EXCLUDES COMMERCIAL CATALOGS, INDUSTRY DIRECTORIES, AND SIMILAR TRADE PUBLICATIONS, REFLECTING GENERAL TYPE DATA ON CERTAIN ENVIRONMENTAL AND PERFORMANCE REQUIREMENTS AND TEST CONDITIONS THAT ARE SHOWN AS "TYPICAL", "AVERAGE", "NOMINAL", ETC.). |