RESISTOR,VARIABLE,NONWIRE WOUND,. Key specifications include body_style: CYLINDRICAL BUSHING MOUNTED, body_length: 0.563 INCHES NOMINAL IN, shaft_style: ROUND, SLOTTED, shaft_length: 0.875 INCHES NOMINAL IN, actuator_type: SINGLE SHAFT, body_diameter: 1.094 INCHES NOMINAL IN. This part is cataloged in the Federal Logistics Information System (FLIS) under NSN 5905-00-557-4811, indicating validated use in U.S.
government and defense logistics supply chains. Available through authorized enterprise resellers and TPM (Third Party Maintenance) channels. Verify compatibility with your specific system configuration before ordering.
| body_style | CYLINDRICAL BUSHING MOUNTED |
| body_length | 0.563 INCHES NOMINAL IN |
| shaft_style | ROUND, SLOTTED |
| shaft_length | 0.875 INCHES NOMINAL IN |
| actuator_type | SINGLE SHAFT |
| body_diameter | 1.094 INCHES NOMINAL IN |
| shaft_diameter | 0.250 INCHES NOMINAL IN |
| mounting_method | STANDARD BUSHING |
| section_quantity | 1 |
| terminal_location | RADIALLY POSITIONED OVER LESS THAN HALF THE CIRCUMFERENCE |
| device_design_type | ERR-030 AT 9:00 OCLOCKUNABLE TO DECODE |
| nonturn_device_radius | 0.531 INCHES NOMINAL IN |
| NSN | 5905-00-557-4811 |
| SHAFT STYLE | ROUND, SLOTTED |
| BODY DIAMETER | 1.094 INCHES NOMINAL IN |
| SHAFT DIAMETER | 0.250 INCHES NOMINAL IN |
| BODY LENGTH | 0.563 INCHES NOMINAL IN |
| MOUNTING BUSHING LENGTH | 0.375 INCHES NOMINAL IN |
| TERMINAL TYPE AND QUANTITY | 3 TAB, SOLDER LUG |
| RESISTANCE TOLERANCE PER SECTION IN PERCENT | -10.0 TO 10.0 SINGLE SECTION |
| AMBIENT TEMP IN DEG CELSIUS PER SECTION AT FULL RATED POWER | 70.0 SINGLE SECTION |
| POWER DISSIPATION RATING PER SECTION IN WATTS | 1.0 FREE AIR SINGLE SECTION |
| TEST DATA DOCUMENT | 81349-MIL-R-94 SPECIFICATION (INCLUDES ENGINEERING TYPE BULLETINS, BROCHURES,ETC., THAT REFLECT SPECIFICATION TYPE DATA IN SPECIFICATION FORMAT; EXCLUDES COMMERCIAL CATALOGS, INDUSTRY DIRECTORIES, AND SIMILAR TRADE PUBLICATIONS, REFLECTING GENERAL TYPE DATA ON CERTAIN ENVIRONMENTAL AND PERFORMANCE REQUIREMENTS AND TEST CONDITIONS THAT ARE SHOWN AS "TYPICAL", "AVERAGE", "NOMINAL", ETC.). |