RESISTOR,VARIABLE,WIRE WOUND,NON. Key specifications include body_style: CYLINDRICAL BUSHING MOUNTED, body_length: 1.410 INCHES MAXIMUM IN, flat_height: 0.211 INCHES MINIMUM AND 0.221 INCHES MAXIMUM IN, shaft_style: ROUND, FLATTED, shaft_length: 0.828 INCHES MINIMUM AND 0.922 INCHES MAXIMUM IN, actuator_type: SINGLE SHAFT. This part is cataloged in the Federal Logistics Information System (FLIS) under NSN 5905-00-636-5169, indicating validated use in U.S.
government and defense logistics supply chains. Available through authorized enterprise resellers and TPM (Third Party Maintenance) channels. Verify compatibility with your specific system configuration before ordering.
| body_style | CYLINDRICAL BUSHING MOUNTED |
| body_length | 1.410 INCHES MAXIMUM IN |
| flat_height | 0.211 INCHES MINIMUM AND 0.221 INCHES MAXIMUM IN |
| shaft_style | ROUND, FLATTED |
| shaft_length | 0.828 INCHES MINIMUM AND 0.922 INCHES MAXIMUM IN |
| actuator_type | SINGLE SHAFT |
| body_diameter | 1.680 INCHES MAXIMUM IN |
| overall_length | 2.332 INCHES MAXIMUM IN |
| shaft_diameter | 0.248 INCHES MINIMUM AND 0.251 INCHES MAXIMUM IN |
| mounting_method | STANDARD BUSHING |
| overall_diameter | 2.260 INCHES MAXIMUM IN |
| section_quantity | 1 |
| NSN | 5905-00-636-5169 |
| FIRST FLAT LENGTH | 0.344 INCHES NOMINAL IN |
| SHAFT LENGTH | 0.828 INCHES MINIMUM AND 0.922 INCHES MAXIMUM IN |
| NONTURN DEVICE RADIUS | 0.485 INCHES MINIMUM AND 0.515 INCHES MAXIMUM IN |
| POWER DISSIPATION RATING PER SECTION IN WATTS | 25.0 HEAT SINK SINGLE SECTION |
| AMBIENT TEMP IN DEG CELSIUS PER SECTION AT FULL RATED POWER | 25.0 SINGLE SECTION |
| TERMINAL LOCATION | RADIALLY POSITIONED OVER LESS THAN HALF THE CIRCUMFERENCE LOCATION NOT OTHERWISE SPECIFIED |
| TEST DATA DOCUMENT | 81349-MIL-R-22 SPECIFICATION (INCLUDES ENGINEERING TYPE BULLETINS, BROCHURES,ETC., THAT REFLECT SPECIFICATION TYPE DATA IN SPECIFICATION FORMAT; EXCLUDES COMMERCIAL CATALOGS, INDUSTRY DIRECTORIES, AND SIMILAR TRADE PUBLICATIONS, REFLECTING GENERAL TYPE DATA ON CERTAIN ENVIRONMENTAL AND PERFORMANCE REQUIREMENTS AND TEST CONDITIONS THAT ARE SHOWN AS "TYPICAL", "AVERAGE", "NOMINAL", ETC.). |
| SPECIFICATION/STANDARD DATA | 81349-MIL-R-22/3 GOVERNMENT SPECIFICATION |
| RESISTANCE TOLERANCE PER SECTION IN PERCENT | -10.0 TO 10.0 SINGLE SECTION |
| TERMINAL TYPE AND QUANTITY | 3 TAB, SOLDER LUG |