SYNCHRO,DIFFERENTIAL TRANSMITTER. Key specifications include length: 0.2500 INCHES NOMINAL SHOULDER IN, body_size: 23, body_style: STANDARD ROUND D, shaft_type: ROUND, THREADED SINGLE SHAFT, pilot_length: 0.0360 INCHES MINIMUM AND 0.0460 INCHES MAXIMUM IN, shaft_length: 0.6930 INCHES MINIMUM AND 0.7190 INCHES MAXIMUM SINGLE SHAFT IN. This part is cataloged in the Federal Logistics Information System under NSN 5990-00-851-2793, indicating validated use in U.S.
government and defense logistics supply chains. Available through authorized enterprise resellers and TPM (Third Party Maintenance) channels. Verify compatibility with your specific system configuration before ordering.
| length | 0.2500 INCHES NOMINAL SHOULDER IN |
| body_size | 23 |
| body_style | STANDARD ROUND D |
| shaft_type | ROUND, THREADED SINGLE SHAFT |
| pilot_length | 0.0360 INCHES MINIMUM AND 0.0460 INCHES MAXIMUM IN |
| shaft_length | 0.6930 INCHES MINIMUM AND 0.7190 INCHES MAXIMUM SINGLE SHAFT IN |
| body_diameter | 1.9850 INCHES MINIMUM AND 1.9900 INCHES MAXIMUM IN |
| body_material | STEEL CORROSION RESISTING |
| overall_length | 4.2940 INCHES MAXIMUM IN |
| pilot_diameter | 0.5900 INCHES MINIMUM AND 0.6000 INCHES MAXIMUM IN |
| shaft_diameter | 0.2402 INCHES MINIMUM AND 0.2405 INCHES MAXIMUM SINGLE SHAFT IN |
| flange_diameter | 2.2490 INCHES MINIMUM AND 2.2500 INCHES MAXIMUM IN |
| NSN | 5990-00-851-2793 |
| ALIGNMENT HOLE QUANTITY | 3 |
| BODY MATERIAL | STEEL CORROSION RESISTING |
| LENGTH | 0.2500 INCHES NOMINAL SHOULDER IN |
| SPECIAL FEATURES | SLOTTED KEYWAY FULL LENGTH OF SHAFT |
| TEST DATA DOCUMENT | 81349-MIL-S-20708 SPECIFICATION (INCLUDES ENGINEERING TYPE BULLETINS, BROCHURES,ETC., THAT REFLECT SPECIFICATION TYPE DATA IN SPECIFICATION FORMAT; EXCLUDES COMMERCIAL CATALOGS, INDUSTRY DIRECTORIES, AND SIMILAR TRADE PUBLICATIONS, REFLECTING GENERAL TYPE DATA ON CERTAIN ENVIRONMENTAL AND PERFORMANCE REQUIREMENTS AND TEST CONDITIONS THAT ARE SHOWN AS "TYPICAL", "AVERAGE", "NOMINAL", ETC.). |
| ZSO RESISTANCE IN OHMS | 217.00 NOMINAL |
| TERMINAL LOCATION | REAR |
| SHAFT THREAD DIRECTION | RIGHT-HAND SINGLE SHAFT |
| BODY STYLE | STANDARD ROUND D |
| FLANGE THICKNESS | 0.2480 INCHES MINIMUM AND 0.2500 INCHES MAXIMUM IN |