MS16212-15: WASHER,FLAT.
The WASHER,FLAT is a the manufacturer industrial component. Key specifications include material: STEEL COMP 302 OR STEEL COMP 304 OR STEEL COMP 316 OR STEEL COMP 321 OVERALL, thickness: 0.108 INCHES MINIMUM AND 0.160 INCHES MAXIMUM IN, hole_diameter: 0.677 INCHES MINIMUM AND 0.697 INCHES MAXIMUM IN, overall_diameter: 1.490 INCHES MINIMUM AND 1.510 INCHES MAXIMUM IN, surface_treatment: PASSIVATE OVERALL, peripheral_shape_style: ROUND. This part is cataloged in the U.S.
Government catalog under NSN 5310-00-491-5895, indicating validated use in U.S. government and defense logistics supply chains. Available through authorized enterprise resellers and TPM (Third Party Maintenance) channels.
Verify compatibility with your specific system configuration before ordering.
| material | STEEL COMP 302 OR STEEL COMP 304 OR STEEL COMP 316 OR STEEL COMP 321 OVERALL |
| thickness | 0.108 INCHES MINIMUM AND 0.160 INCHES MAXIMUM IN |
| hole_diameter | 0.677 INCHES MINIMUM AND 0.697 INCHES MAXIMUM IN |
| overall_diameter | 1.490 INCHES MINIMUM AND 1.510 INCHES MAXIMUM IN |
| surface_treatment | PASSIVATE OVERALL |
| peripheral_shape_style | ROUND |
| center_hole_shape_style | ROUND |
| minimum_tensile_strength | 50000 POUNDS PER SQUARE INCH LBS |
| cross-sectional_shape_style | RECTANGULAR |
| nondefinitive_spec/std_data | A TYPE AND 1 GRADE AND B CLASS |
| material_document_and_classification | QQ-S-766 FINISH NO. 2 FED SPEC 1ST MATERIAL RESPONSE OVERALL |
| surface_treatment_document_and_classification | QQ-P-35 FED SPEC SINGLE TREATMENT RESPONSE OVERALL |
| NSN | 5310-00-491-5895 |
| SURFACE TREATMENT DOCUMENT AND CLASSIFICATION | QQ-P-35 FED SPEC SINGLE TREATMENT RESPONSE OVERALL |
| OVERALL DIAMETER | 1.490 INCHES MINIMUM AND 1.510 INCHES MAXIMUM IN |
| MATERIAL DOCUMENT AND CLASSIFICATION | QQ-S-766 FINISH NO. 2 FED SPEC 1ST MATERIAL RESPONSE OVERALL |
| CROSS-SECTIONAL SHAPE STYLE | RECTANGULAR |
| NONDEFINITIVE SPEC/STD DATA | A TYPE AND 1 GRADE AND B CLASS |
| SURFACE TREATMENT | PASSIVATE OVERALL |
| MINIMUM TENSILE STRENGTH | 50000 POUNDS PER SQUARE INCH LBS |
| PERIPHERAL SHAPE STYLE | ROUND |
| TEST DATA DOCUMENT | 81349-MIL-I-17214 SPECIFICATION (INCLUDES ENGINEERING TYPE BULLETINS, BROCHURES,ETC., THAT REFLECT SPECIFICATION TYPE DATA IN SPECIFICATION FORMAT; EXCLUDES COMMERCIAL CATALOGS, INDUSTRY DIRECTORIES, AND SIMILAR TRADE PUBLICATIONS, REFLECTING GENERAL TYPE DATA ON CERTAIN ENVIRONMENTAL AND PERFORMANCE REQUIREMENTS AND TEST CONDITIONS THAT ARE SHOWN AS "TYPICAL", "AVERAGE", "NOMINAL", ETC.). |
| MATERIAL | STEEL COMP 302 OR STEEL COMP 304 OR STEEL COMP 316 OR STEEL COMP 321 OVERALL |