RESISTOR,VARIABLE,WIRE WOUND,NON. Key specifications include body_style: RECTANGULAR W/MOUNTING HOLES/SLOTS, body_width: 0.190 INCHES NOMINAL IN, body_height: 0.315 INCHES NOMINAL IN, body_length: 1.250 INCHES NOMINAL IN, shaft_style: ROUND, SLOTTED, shaft_length: 0.058 INCHES NOMINAL IN. This part is cataloged in the Federal Logistics Information System under NSN 5905-01-062-5861, indicating validated use in U.S.
government and defense logistics supply chains. Available through authorized enterprise resellers and TPM (Third Party Maintenance) channels. Verify compatibility with your specific system configuration before ordering.
| body_style | RECTANGULAR W/MOUNTING HOLES/SLOTS |
| body_width | 0.190 INCHES NOMINAL IN |
| body_height | 0.315 INCHES NOMINAL IN |
| body_length | 1.250 INCHES NOMINAL IN |
| shaft_style | ROUND, SLOTTED |
| shaft_length | 0.058 INCHES NOMINAL IN |
| actuator_type | SINGLE SHAFT |
| overall_width | 0.190 INCHES NOMINAL IN |
| overall_height | 0.815 INCHES NOMINAL IN |
| overall_length | 1.308 INCHES NOMINAL IN |
| shaft_diameter | 0.115 INCHES NOMINAL IN |
| mounting_method | TERMINAL AND UNTHREADED HOLE(S) |
| NSN | 5905-01-062-5861 |
| SHAFT STYLE | ROUND, SLOTTED |
| LATERAL DISTANCE BETWEEN MOUNTING HOLE CENTERS | 1.000 INCHES NOMINAL IN |
| BODY WIDTH | 0.190 INCHES NOMINAL IN |
| BODY LENGTH | 1.250 INCHES NOMINAL IN |
| TERMINAL LENGTH | 0.500 INCHES NOMINAL IN |
| MOUNTING METHOD | TERMINAL AND UNTHREADED HOLE(S) |
| RESISTANCE TOLERANCE PER SECTION IN PERCENT | -5.0 TO 5.0 SINGLE SECTION |
| TERMINAL LOCATION | LOWER ADJACENT SIDE TWO ROWS LOCATION NOT OTHERWISE SPECIFIED |
| AMBIENT TEMP IN DEG CELSIUS PER SECTION AT FULL RATED POWER | 85.0 SINGLE SECTION |
| TEST DATA DOCUMENT | 81349-MIL-R-39015 SPECIFICATION (INCLUDES ENGINEERING TYPE BULLETINS, BROCHURES,ETC., THAT REFLECT SPECIFICATION TYPE DATA IN SPECIFICATION FORMAT; EXCLUDES COMMERCIAL CATALOGS, INDUSTRY DIRECTORIES, AND SIMILAR TRADE PUBLICATIONS, REFLECTING GENERAL TYPE DATA ON CERTAIN ENVIRONMENTAL AND PERFORMANCE REQUIREMENTS AND TEST CONDITIONS THAT ARE SHOWN AS "TYPICAL", "AVERAGE", "NOMINAL", ETC.). |