H832-1651-23A: SHAFT,SHOULDERED.
The SHAFT,SHOULDERED is a the manufacturer industrial component. Key specifications include material: STEEL, overall_length: 2.760 INCHES NOMINAL IN, end_item_identification: NSSN CLASS SUBMARINE, material_document_and_classification: ASTM-A564 FED SPEC SINGLE MATERIAL RESPONSE, part_name_assigned_by_controlling_agency: QUILL SHAFT. This part is cataloged in the U.S.
Government catalog under NSN 3040-01-475-0328, indicating validated use in U.S. government and defense logistics supply chains. Available through authorized enterprise resellers and TPM (Third Party Maintenance) channels.
Verify compatibility with your specific system configuration before ordering.
| material | STEEL |
| step_quantity | 1 |
| overall_length | 2.760 INCHES NOMINAL IN |
| end_item_identification | NSSN CLASS SUBMARINE |
| material_document_and_classification | ASTM-A564 FED SPEC SINGLE MATERIAL RESPONSE |
| part_name_assigned_by_controlling_agency | QUILL SHAFT |
| NSN | 3040-01-475-0328 |
| STEP QUANTITY | 1 |
| MATERIAL DOCUMENT AND CLASSIFICATION | ASTM-A564 FED SPEC SINGLE MATERIAL RESPONSE |
| OVERALL LENGTH | 2.760 INCHES NOMINAL IN |
| SPECIAL FEATURES | MATERIAL IS STAINLESS STEEL; THIS PART OF WEAPONS HANDLING ATHWARTSHIP DRIVE GEARBOX SUB ASSEMBLY; PROTECT THIS SURFACE PRIOR TO ASSEMBLY; ANGULAR RELATIONSHIP OF SPLINE 1 TEETH MAY VARY FREELY, AS A UNIT, TO SPLINE 2 TEETH; REMOVE ALL BURRS AND SHARP EDGES, AND WHERE MACHINED CORNER OR FILLET RADII ARE NOT DIMENSIONED. .015 MAXIMUM REDIUS SHALL BE USED |
| PART NAME ASSIGNED BY CONTROLLING AGENCY | QUILL SHAFT |
| END ITEM IDENTIFICATION | NSSN CLASS SUBMARINE |
| MATERIAL | STEEL |