CR597308: SEAL,PLAIN.
The SEAL,PLAIN is a the manufacturer industrial component. Key specifications include seal_width: 1.125 INCHES NOMINAL IN, housing_bore_diameter: 0.937 INCHES NOMINAL IN, part_name_assigned_by_controlling_agency: AXIAL CLAMP SEALS CT3 DESIGN. This part is cataloged in the U.S.
Government catalog under NSN 5330-01-557-7603, indicating validated use in U.S. government and defense logistics supply chains. Available through authorized enterprise resellers and TPM (Third Party Maintenance) channels.
Verify compatibility with your specific system configuration before ordering.
| seal_width | 1.125 INCHES NOMINAL IN |
| housing_bore_diameter | 0.937 INCHES NOMINAL IN |
| part_name_assigned_by_controlling_agency | AXIAL CLAMP SEALS CT3 DESIGN |
| NSN | 5330-01-557-7603 |
| SEAL WIDTH | 1.125 INCHES NOMINAL IN |
| HOUSING BORE DIAMETER | 0.937 INCHES NOMINAL IN |
| SPECIAL FEATURES | SKF AXIAL CLAMP SEALS ARE PRODUCED IN THREE DIFFERENT DESIGNS:CT1, CT3, AND CT4 DESIGN; THESE AXIAL CLAMP SEALS ARE MADE OF APPROPRIATELY PROFILED STRIPS OF NON-REINFORCED NITRILE RUBBER WHICH ARE HELD FIRMLY IN PLACE BY STAINLESS STEEL SCREW-TYPE CLAMPS; THEY ARE AVAILABLE IN THE DIAMETER RANGE 150 TO 4600 MM; THE SEALS DO NOT ROTATE BUT SEAL AXIALLY AGAINST A ROTATING COUNTERFACE; CT3 DESIGN:THE SEALS OF THE CT3 DESIGN DIFFER FROM THOSE OF THE CT1 DESIGN ONLY IN THE FORM OF THE SEALING LIP; THIS IS AGAIN FLAT BUT IS PROVIDED WITH ANNULAR GROOVES; THESE SERVE TO TRAP CONTAMINANTS WHICH MAY HAVE STARTED TO PENETRATE THE LIP/COUNTERFACE CONTACT; THE MAXIMUM OPERATING INTERFERENCE FOR THESE SEALS IS +4,8 MM; SHAFT:42.500 IN.; OD:43.688 IN.; WEIGHT:4.250 LBS LBS |
| PART NAME ASSIGNED BY CONTROLLING AGENCY | AXIAL CLAMP SEALS CT3 DESIGN |
No substitute or cross-reference records for this part.