CAPACITOR,FIXED,CERAMIC DIELECTR. Key specifications include material: CERAMIC OR GLASS CASE, body_style: CHIP TYPE, body_width: 0.110 INCHES NOMINAL IN, body_height: 0.030 INCHES MINIMUM AND 0.102 INCHES MAXIMUM IN, body_length: 0.090 INCHES MINIMUM AND 0.145 INCHES MAXIMUM IN, terminal_length: 0.015 INCHES NOMINAL IN. This part is cataloged in the Federal Logistics Information System (FLIS) under NSN 5910-01-256-2665, indicating validated use in U.S.
government and defense logistics supply chains. Available through authorized enterprise resellers and TPM (Third Party Maintenance) channels. Verify compatibility with your specific system configuration before ordering.
| material | CERAMIC OR GLASS CASE |
| body_style | CHIP TYPE |
| body_width | 0.110 INCHES NOMINAL IN |
| body_height | 0.030 INCHES MINIMUM AND 0.102 INCHES MAXIMUM IN |
| body_length | 0.090 INCHES MINIMUM AND 0.145 INCHES MAXIMUM IN |
| terminal_length | 0.015 INCHES NOMINAL IN |
| reliability_indicator | ESTABLISHED |
| nonderated_operating_temp | -55.0 CELSIUS MINIMUM AND 125.0 CELSIUS MAXIMUM DEGC |
| terminal_surface_treatment | SOLDER |
| terminal_type_and_quantity | 2 BONDING PAD |
| specification/standard_data | 81349-MIL-C-55681/4 GOVERNMENT SPECIFICATION |
| tolerance_range_per_section | -2.00 TO 2.00 PERCENT SINGLE SECTION |
| NSN | 5910-01-256-2665 |
| BODY STYLE | CHIP TYPE |
| RELIABILITY FAILURE RATE LEVEL IN PERCENT | 0.010 |
| TEMP COEFFICIENT OF CAPACITANCE PER SECTION IN PPM PER DEG CELSIUS | 90.0 SINGLE SECTION |
| BODY LENGTH | 0.090 INCHES MINIMUM AND 0.145 INCHES MAXIMUM IN |
| BODY WIDTH | 0.110 INCHES NOMINAL IN |
| SCHEMATIC DIAGRAM DESIGNATOR | NO COMMON OR GROUNDED ELECTRODE(S) |
| TOLERANCE OF TEMP COEFFICIENT PER SECTION IN PPM PER DEG CELSIUS | -20.0 TO 20.0 SINGLE SECTION |
| BODY HEIGHT | 0.030 INCHES MINIMUM AND 0.102 INCHES MAXIMUM IN |
| NONDERATED CONTINUOUS VOLTAGE RATING AND TYPE PER SECTION | 500.0 DC SINGLE SECTION |
| TEST DATA DOCUMENT | 81349-MIL-C-55681 SPECIFICATION (INCLUDES ENGINEERING TYPE BULLETINS, BROCHURES,ETC., THAT REFLECT SPECIFICATION TYPE DATA IN SPECIFICATION FORMAT; EXCLUDES COMMERCIAL CATALOGS, INDUSTRY DIRECTORIES, AND SIMILAR TRADE PUBLICATIONS, REFLECTING GENERAL TYPE DATA ON CERTAIN ENVIRONMENTAL AND PERFORMANCE REQUIREMENTS AND TEST CONDITIONS THAT ARE SHOWN AS "TYPICAL", "AVERAGE", "NOMINAL", ETC.). |