RESISTOR,VARIABLE,WIRE WOUND,PRE. Key specifications include base_type: STANDARD BASE, reed_type: SINGLE, unit_type: ELECTROMECHANICAL, body_style: CYLINDRICAL SERVO MOUNTED, body_length: 2.469 INCHES NOMINAL IN, shaft_style: ROUND. This product is currently in active production with full OEM support.
This part is cataloged in the Federal Logistics Information System (FLIS) under NSN 5905-00-316-0546, indicating validated use in U.S. government and defense logistics supply chains. Available through authorized enterprise resellers and TPM (Third Party Maintenance) channels.
Verify compatibility with your specific system configuration before ordering.
| base_type | STANDARD BASE |
| reed_type | SINGLE |
| unit_type | ELECTROMECHANICAL |
| body_style | CYLINDRICAL SERVO MOUNTED |
| body_length | 2.469 INCHES NOMINAL IN |
| shaft_style | ROUND |
| pilot_length | 0.1000 INCHES NOMINAL IN |
| shaft_length | 1.000 INCHES NOMINAL IN |
| actuator_type | SINGLE SHAFT |
| body_diameter | 3.031 INCHES MAXIMUM IN |
| end_item_name | ENGINE HEATER |
| terminal_type | PIN |
| NSN | 5905-00-316-0546 |
| ANGLE OF MOUNTING HOLE IN DEG | 90.0 |
| SCREW THREAD DIAMETER | 0.138 INCHES NOMINAL IN |
| AMBIENT TEMP IN DEG CELSIUS PER SECTION AT ZERO PERCENT RATED POWER | 85.0 ALL SECTIONS |
| ACTUATOR TYPE | SINGLE SHAFT |
| MOUNTING FACILITY QUANTITY | 3 |
| UNDERCUT DIAMETER | 3.000 INCHES NOMINAL IN |
| ANGLE BETWEEN CENTERLINES OF MOUNTING HOLES IN DEG | 120.0 |
| SHAFT DIAMETER | 0.250 INCHES NOMINAL IN |
| MOUNTING METHOD | THREADED HOLE(S) |
| ROTARY ACTUATOR TRAVEL IN ANGULAR DEG | 360.0 NOMINAL |