CLAMP,CABLE,ELECTRICAL CONNECTOR. Key specifications include material: STEEL WASHER, alignment_type: RIGID, overall_height: 0.8070 INCHES NOMINAL IN, surface_finish: GROUND, special_features: NOTCH CUT IN BEARING TO PERMIT PASSAGE OF GREASE TO BALL AND RETAINER,BANDED OD, style_designator: CLUTCH RELEASE, THRUST, LUBRICATED AND SEALED. This part is cataloged in the Federal Logistics Information System (FLIS) under NSN 3110-00-198-1624, indicating validated use in U.S.
government and defense logistics supply chains. Available through authorized enterprise resellers and TPM (Third Party Maintenance) channels. Verify compatibility with your specific system configuration before ordering.
| material | STEEL WASHER |
| alignment_type | RIGID |
| overall_height | 0.8070 INCHES NOMINAL IN |
| surface_finish | GROUND |
| special_features | NOTCH CUT IN BEARING TO PERMIT PASSAGE OF GREASE TO BALL AND RETAINER,BANDED OD |
| style_designator | CLUTCH RELEASE, THRUST, LUBRICATED AND SEALED |
| bore_smallest_diameter | 2.2490 INCHES MINIMUM AND 2.2500 INCHES MAXIMUM IN |
| overall_outside_diameter | 3.8120 INCHES NOMINAL IN |
| retainer_fabrication_method | MACHINED |
| thrust_directional_capability_designation | SINGLE |
| NSN | 3110-00-198-1624 |
| OVERALL OUTSIDE DIAMETER | 3.8120 INCHES NOMINAL IN |
| THRUST DIRECTIONAL CAPABILITY DESIGNATION | SINGLE |
| SURFACE FINISH | GROUND |
| BORE SMALLEST DIAMETER | 2.2490 INCHES MINIMUM AND 2.2500 INCHES MAXIMUM IN |
| SPECIAL FEATURES | NOTCH CUT IN BEARING TO PERMIT PASSAGE OF GREASE TO BALL AND RETAINER,BANDED OD |
| ALIGNMENT TYPE | RIGID |
| RETAINER FABRICATION METHOD | MACHINED |
| MATERIAL | COPPER ALLOY RETAINER |
| STYLE DESIGNATOR | CLUTCH RELEASE, THRUST, LUBRICATED AND SEALED |
| ALIGNMENT TYPE | RIGID |