The V-BLOCK is a the manufacturer industrial component. Key specifications include width: 1.875 INCHES NOMINAL IN, height: 1.875 INCHES NOMINAL IN, length: 3.625 INCHES NOMINAL IN, material: STEEL, hole_type: TAPPED, design_type: CLAMP. This product is currently in active production with full OEM support.
This part is cataloged in the Federal Logistics Information System (FLIS) under NSN 3460-00-265-7095, indicating validated use in U.S. government and defense logistics supply chains. Available through authorized enterprise resellers and TPM (Third Party Maintenance) channels.
Verify compatibility with your specific system configuration before ordering.
| width | 1.875 INCHES NOMINAL IN |
| height | 1.875 INCHES NOMINAL IN |
| length | 3.625 INCHES NOMINAL IN |
| material | STEEL |
| hole_type | TAPPED |
| design_type | CLAMP |
| thread_size | 0.375-16 |
| vee_location | TOP AND END STEP |
| vee_quantity | 2 |
| surface_finish | GROUND |
| hardening_feature | INCLUDED |
| tapped_hole_location | IN BASE AND IN SIDES |
| NSN | 3460-00-265-7095 |
| TAPPED HOLE LOCATION | IN BASE AND IN SIDES |
| WIDTH | 1.875 INCHES NOMINAL IN |
| SURFACE FINISH | GROUND |
| MATERIAL | STEEL |
| TAPPED HOLE QUANTITY | 4 |
| THREAD SIZE | 0.375-16 |
| MAXIMUM MATERIAL DIAMETER ACCOMMODATED | 1.312 INCHES IN |
| HARDENING FEATURE | INCLUDED |
| ACCESSORY COMPONENTS AND QUANTITY | CLAMP,YOKE TYPE 1,SCREWS 2 |
| MILLED GROOVE LOCATION AND QUANTITY | 2 EACH SIDE AND 1 END STEP |