CAPACITOR,FIXED,MICA DIELECTRIC. Key specifications include material: PLASTIC CASE, body_style: W/O MTG FACILITIES, TERMINALS ON OPPOSITE SURFACES, body_width: 0.250 INCHES NOMINAL IN, body_height: 0.800 INCHES NOMINAL IN, body_length: 0.800 INCHES NOMINAL IN, terminal_length: 1.120 INCHES MINIMUM IN. This part is cataloged in the Federal Logistics Information System (FLIS) under NSN 5910-00-067-6514, indicating validated use in U.S.
government and defense logistics supply chains. Available through authorized enterprise resellers and TPM (Third Party Maintenance) channels. Verify compatibility with your specific system configuration before ordering.
| material | PLASTIC CASE |
| body_style | W/O MTG FACILITIES, TERMINALS ON OPPOSITE SURFACES |
| body_width | 0.250 INCHES NOMINAL IN |
| body_height | 0.800 INCHES NOMINAL IN |
| body_length | 0.800 INCHES NOMINAL IN |
| terminal_length | 1.120 INCHES MINIMUM IN |
| reliability_indicator | NOT ESTABLISHED |
| nonderated_operating_temp | -55.0 CELSIUS MINIMUM AND 125.0 CELSIUS MAXIMUM DEGC |
| terminal_surface_treatment | SOLDER |
| terminal_type_and_quantity | 2 UNINSULATED WIRE LEAD |
| tolerance_range_per_section | -2.00 TO 2.00 PERCENT SINGLE SECTION |
| schematic_diagram_designator | NO COMMON OR GROUNDED ELECTRODE(S) |
| NSN | 5910-00-067-6514 |
| INSULATION RESISTANCE AT MAXIMUM OPERATING TEMP | 10000.0 MEGOHMS |
| NONDERATED CONTINUOUS VOLTAGE RATING AND TYPE PER SECTION | 500.0 DC SINGLE SECTION |
| DISSIPATION FACTOR AT REFERENCE TEMP IN PERCENT | 0.0010 |
| TEMP COEFFICIENT OF CAPACITANCE RANGE PER SECTION IN PPM PER DEG CELSIUS | +0.0 TO 70.0 SINGLE SECTION |
| TOLERANCE RANGE PER SECTION | -2.00 TO 2.00 PERCENT SINGLE SECTION |
| TEST DATA DOCUMENT | 81349-MIL-C-5 SPECIFICATION (INCLUDES ENGINEERING TYPE BULLETINS, BROCHURES,ETC., THAT REFLECT SPECIFICATION TYPE DATA IN SPECIFICATION FORMAT; EXCLUDES COMMERCIAL CATALOGS, INDUSTRY DIRECTORIES, AND SIMILAR TRADE PUBLICATIONS, REFLECTING GENERAL TYPE DATA ON CERTAIN ENVIRONMENTAL AND PERFORMANCE REQUIREMENTS AND TEST CONDITIONS THAT ARE SHOWN AS "TYPICAL", "AVERAGE", "NOMINAL", ETC.). |
| SCHEMATIC DIAGRAM DESIGNATOR | NO COMMON OR GROUNDED ELECTRODE(S) |
| BODY LENGTH | 0.800 INCHES NOMINAL IN |
| TERMINAL TYPE AND QUANTITY | 2 UNINSULATED WIRE LEAD |
| BODY WIDTH | 0.250 INCHES NOMINAL IN |