7033582: LEVER,REMOTE CONTROL.
The LEVER,REMOTE CONTROL is a the manufacturer industrial component. Key specifications include material: STEEL, bore_type: SERRATED, overall_width: 1.330 INCHES MINIMUM AND 1.350 INCHES MAXIMUM IN, major_diameter: 0.875 INCHES NOMINAL IN, minor_diameter: 0.833 INCHES MINIMUM AND 0.835 INCHES MAXIMUM IN, special_features: OFFSET HEIGHT: 0.800 IN. MINIMUM AND 0.820 IN.
MAXIMUM IN. This part is cataloged in the U.S. Government catalog under NSN 3040-00-089-8288, indicating validated use in U.S.
government and defense logistics supply chains. Available through authorized enterprise resellers and TPM (Third Party Maintenance) channels. Verify compatibility with your specific system configuration before ordering.
| material | STEEL |
| bore_type | SERRATED |
| overall_width | 1.330 INCHES MINIMUM AND 1.350 INCHES MAXIMUM IN |
| major_diameter | 0.875 INCHES NOMINAL IN |
| minor_diameter | 0.833 INCHES MINIMUM AND 0.835 INCHES MAXIMUM IN |
| special_features | OFFSET HEIGHT: 0.800 IN. MINIMUM AND 0.820 IN. MAXIMUM IN |
| features_provided | COUNTERBORE |
| surface_treatment | ZINC |
| link_end_thickness | 0.490 INCHES MINIMUM AND 0.510 INCHES MAXIMUM IN |
| serration_quantity | 48 |
| shaft_end_thickness | 1.240 INCHES MINIMUM AND 1.260 INCHES MAXIMUM IN |
| shaft_securing_method | SERRATIONS |
| NSN | 3040-00-089-8288 |
| LINK END THICKNESS | 0.490 INCHES MINIMUM AND 0.510 INCHES MAXIMUM IN |
| LINK END HOLE DIAMETER | 0.550 INCHES MINIMUM AND 0.570 INCHES MAXIMUM IN |
| SHAFT END THICKNESS | 1.240 INCHES MINIMUM AND 1.260 INCHES MAXIMUM IN |
| MATERIAL DOCUMENT AND CLASSIFICATION | MIL-S-13048 FS 1035 TO FS1038 MIL SPEC SINGLE MATERIAL RESPONSE |
| OVERALL WIDTH | 1.330 INCHES MINIMUM AND 1.350 INCHES MAXIMUM IN |
| BORE TYPE | SERRATED |
| SHAFT SECURING METHOD | SERRATIONS |
| FEATURES PROVIDED | COUNTERBORE |
| CENTER TO CENTER DISTANCE BETWEEN LINK AND SHAFT HOLES | 5.990 INCHES MINIMUM AND 6.010 INCHES MAXIMUM IN |
| SERRATION QUANTITY | 48 |