55-115-012: RESISTOR,VARIABLE,WIRE WOUND,PRE.
RESISTOR,VARIABLE,WIRE WOUND,PRE. Key specifications include shaft_style: ROUND, bearing_type: SLEEVE SHAFT, actuator_type: DOUBLE ENDED SHAFT, shaft_diameter: 0.250 INCHES NOMINAL IN, mounting_method: THREADED HOLE(S), special_features: SHAFT NOT FURNISHED. This part is cataloged in the U.S.
Government catalog under NSN 5905-00-026-7906, indicating validated use in U.S. government and defense logistics supply chains. Available through authorized enterprise resellers and TPM (Third Party Maintenance) channels.
Verify compatibility with your specific system configuration before ordering.
| shaft_style | ROUND |
| bearing_type | SLEEVE SHAFT |
| actuator_type | DOUBLE ENDED SHAFT |
| shaft_diameter | 0.250 INCHES NOMINAL IN |
| mounting_method | THREADED HOLE(S) |
| section_quantity | 1 |
| special_features | SHAFT NOT FURNISHED |
| terminal_location | RADIALLY POSITIONED OVER LESS THAN HALF THE CIRCUMFERENCE LOCATION NOT OTHERWISE SPECIFIED |
| screw_thread_diameter | 0.164 INCHES NOMINAL IN |
| mounting_facility_quantity | 3 |
| terminal_type_and_quantity | 4 PIN |
| fixed_tap_quantity_per_section | 1 SINGLE SECTION |
| NSN | 5905-00-026-7906 |
| SCREW THREAD QUANTITY PER INCH | 32.0 |
| ELECTRICAL RESISTANCE PER SECTION | 1.000 KILOHMS SINGLE SECTION |
| SECTION QUANTITY | 1 |
| MOUNTING FACILITY QUANTITY | 3 |
| SHAFT DIAMETER | 0.250 INCHES NOMINAL IN |
| FUNCTION CHARACTERISTIC PER SECTION | SINGLE SECTION TABLE |
| TAP LOCATION FROM CCW TERMINAL PER SECTION IN OHMS | 500.0 SINGLE SECTION |
| MOUNTING METHOD | THREADED HOLE(S) |
| TEMP COEFFICIENT OF RESISTANCE WIRE PER SECTION IN PPM PER DEG CELSIUS | -20.0 TO 20.0 SINGLE SECTION |
| FIXED TAP QUANTITY PER SECTION | 1 SINGLE SECTION |