The SCREW,MACHINE is a the manufacturer industrial component. Key specifications include head_style: FLAT COUNTERSUNK, thread_class: 2A A, head_diameter: 0.244 INCHES MINIMUM AND 0.279 INCHES MAXIMUM IN, thread_length: 0.699 INCHES MINIMUM AND 0.875 INCHES MAXIMUM IN, screw_material: STEEL, fastener_length: 0.844 INCHES MINIMUM AND 0.875 INCHES MAXIMUM IN. This part is cataloged in the Federal Logistics Information System (FLIS) under NSN 5305-00-958-5461, indicating validated use in U.S.
government and defense logistics supply chains. Available through authorized enterprise resellers and TPM (Third Party Maintenance) channels. Verify compatibility with your specific system configuration before ordering.
| head_style | FLAT COUNTERSUNK |
| thread_class | 2A A |
| head_diameter | 0.244 INCHES MINIMUM AND 0.279 INCHES MAXIMUM IN |
| thread_length | 0.699 INCHES MINIMUM AND 0.875 INCHES MAXIMUM IN |
| screw_material | STEEL |
| fastener_length | 0.844 INCHES MINIMUM AND 0.875 INCHES MAXIMUM IN |
| thread_direction | RIGHT-HAND |
| countersink_angle | 80.0 DEGREES MINIMUM AND 82.0 DEGREES MAXIMUM |
| internal_drive_style | CROSS RECESS TYPE 1 |
| nominal_thread_diameter | 0.138 INCHES IN |
| screw_surface_treatment | CADMIUM AND CHROMATE |
| minimum_tensile_strength | 60000 POUNDS PER SQUARE INCH LBS |
| NSN | 5305-00-958-5461 |
| INTERNAL DRIVE STYLE | CROSS RECESS TYPE 1 |
| NOMINAL THREAD DIAMETER | 0.138 INCHES IN |
| THREAD SERIES DESIGNATOR | UNIFIED NATIONAL COARSE (UNC) |
| THREAD LENGTH | 0.699 INCHES MINIMUM AND 0.875 INCHES MAXIMUM IN |
| SCREW MATERIAL | STEEL |
| THREAD CLASS | 2A A |
| THREAD DIRECTION | RIGHT-HAND |
| FASTENER LENGTH | 0.844 INCHES MINIMUM AND 0.875 INCHES MAXIMUM IN |
| SCREW MATERIAL DOCUMENT AND CLASSIFICATION | 66 FED STD SINGLE MATERIAL RESPONSE OR ASTMA108 ASSN STD SINGLE MATERIAL RESPONSE |
| MINIMUM TENSILE STRENGTH | 60000 POUNDS PER SQUARE INCH LBS |