Bactrian camels have been domesticated for such a long period of time that we may never know what their original habitats were like. Their two-humped bodies are perfect for desert travel. They have broad feet for walking on sand.
Their long eyelashes shield their eyes from sand, and their nostrils close to keep sand out. The humps on their backs actually store energy for when they have a long journey ahead of them. Camels can survive without water for long periods of time and can lose about forty percent of their body weight in water.
(Other animals can only safely lose twenty percent.) Camels can also drink salty water and have been known to drink one third of their body weight in ten minutes! The thick fur on their head and hump shed annually. Camels roam in female herds accompanied by one adult male. Other males live alone or in bachelor groups.
- Fun Fact : The camel can reach speeds of forty miles per hour when running. - Scientific Name : Camelus bactrianus - Conservation Status This part is cataloged in the Federal Logistics Information System (FLIS) under NSN 5305-00-432-2812, indicating validated use in U.S. government and defense logistics supply chains.
| length | 4.0 CENTIMETERS NOMINAL CM |
| material | RUBBER BUTADIENE-ACRYLONITRILE CLASS NBR |
| duty_type | CONTINUOUS |
| head_style | FLAT CHAMFER |
| time_delay | 6.00 SECONDS MINIMUM AND 60.00 SECONDS MAXIMUM ADJUSTABLE OPERATE TIME |
| head_height | 0.057 INCHES MINIMUM AND 0.067 INCHES MAXIMUM IN |
| storage_type | GENERAL PURPOSE WAREHOUSE |
| thread_class | 2A A |
| tip_diameter | 5.0 MILLIMETERS NOMINAL MM |
| coil_quantity | 1 |
| cubic_measure | 13.264 CUBIC INCHES |
| head_diameter | 0.140 INCHES MINIMUM AND 0.150 INCHES MAXIMUM IN |
| NSN | 5305-00-432-2812 |
| INTERNAL DRIVE STYLE | SLOT |
| THREAD LENGTH | 0.214 INCHES MINIMUM AND 0.224 INCHES MAXIMUM IN |
| SCREW MATERIAL | COPPER ALLOY |
| THREAD SERIES DESIGNATOR | UNIFIED NATIONAL COARSE (UNC) |
| THREAD QUANTITY PER INCH | 40 |
| FASTENER LENGTH | 0.370 INCHES MINIMUM AND 0.380 INCHES MAXIMUM IN |
| PART NAME ASSIGNED BY CONTROLLING AGENCY | NAVY SPECIAL PROJECT |
| THREAD CLASS | 2A A |
| HEAD DIAMETER | 0.140 INCHES MINIMUM AND 0.150 INCHES MAXIMUM IN |
| HEAD STYLE | FLAT CHAMFER |