134206: RESISTOR,VARIABLE,WIRE WOUND,PRE.
RESISTOR,VARIABLE,WIRE WOUND,PRE. Key specifications include material: STEEL OVERALL, end_style: SPRING END,SQUARED AND GROUND BOTH ENDS, load_rating: 2010.000 POUNDS NOMINAL LBS, shaft_style: ROUND, MILLED, SPRING SLIT, shaft_length: 0.688 INCHES NOMINAL IN, actuator_type: SINGLE SHAFT. This part is cataloged in the U.S.
Government catalog under NSN 5905-00-925-4392, indicating validated use in U.S. government and defense logistics supply chains. Available through authorized enterprise resellers and TPM (Third Party Maintenance) channels.
Verify compatibility with your specific system configuration before ordering.
| material | STEEL OVERALL |
| end_style | SPRING END,SQUARED AND GROUND BOTH ENDS |
| load_rating | 2010.000 POUNDS NOMINAL LBS |
| shaft_style | ROUND, MILLED, SPRING SLIT |
| shaft_length | 0.688 INCHES NOMINAL IN |
| actuator_type | SINGLE SHAFT |
| inside_diameter | 1.020 INCHES MINIMUM AND 1.070 INCHES MAXIMUM IN |
| mounting_method | STANDARD BUSHING |
| section_quantity | 1 |
| special_features | CENTER SECTION |
| style_designator | CYLINDRICAL |
| surface_treatment | CADMIUM OVERALL |
| NSN | 5905-00-925-4392 |
| NONTURN DEVICE LOCATION | AT 9 OCLOCK |
| SCREW THREAD QUANTITY PER INCH | 32.0 |
| ELECTRICAL RESISTANCE PER SECTION | 250.000 KILOHMS SINGLE SECTION |
| SECTION QUANTITY | 1 |
| MOUNTING METHOD | STANDARD BUSHING |
| TERMINAL LOCATION | RADIALLY POSITIONED OVER LESS THAN HALF THE CIRCUMFERENCE LOCATION NOT OTHERWISE SPECIFIED |
| SHAFT STYLE | ROUND, MILLED, SPRING SLIT |
| ACTUATOR TYPE | SINGLE SHAFT |
| SHAFT LENGTH | 0.688 INCHES NOMINAL IN |
| SCREW THREAD DIAMETER | 0.375 INCHES NOMINAL IN |