RESISTOR,VARIABLE,WIRE WOUND,PRE. Key specifications include material: STEEL OVERALL, alignment_type: RIGID, overall_height: 0.8070 INCHES NOMINAL IN, surface_finish: GROUND, bore_smallest_diameter: 2.0000 INCHES MINIMUM AND 2.0010 INCHES MAXIMUM IN, overall_outside_diameter: 3.6870 INCHES NOMINAL IN. This part is cataloged in the Federal Logistics Information System (FLIS) under NSN 3110-00-293-8165, indicating validated use in U.S.
government and defense logistics supply chains. Available through authorized enterprise resellers and TPM (Third Party Maintenance) channels. Verify compatibility with your specific system configuration before ordering.
| material | STEEL OVERALL |
| alignment_type | RIGID |
| overall_height | 0.8070 INCHES NOMINAL IN |
| surface_finish | GROUND |
| special_features | BRONZE FERRULE IN ID OF LARGE WASHER,LARGE WASHER UNDER CUT TO RETAIN FERRULE,LUBRICATING NOTCH CUT IN ID OF SMALL WASHER,WASHERS OVERLAP,BANDED OD |
| bore_smallest_diameter | 2.0000 INCHES MINIMUM AND 2.0010 INCHES MAXIMUM IN |
| overall_outside_diameter | 3.6870 INCHES NOMINAL IN |
| retainer_fabrication_method | PRESSED |
| thrust_directional_capability_designation | SINGLE |
| NSN | 3110-00-293-8165 |
| BORE SMALLEST DIAMETER | 2.0000 INCHES MINIMUM AND 2.0010 INCHES MAXIMUM IN |
| OVERALL OUTSIDE DIAMETER | 3.6870 INCHES NOMINAL IN |
| THRUST DIRECTIONAL CAPABILITY DESIGNATION | SINGLE |
| SPECIAL FEATURES | BRONZE FERRULE IN ID OF LARGE WASHER,LARGE WASHER UNDER CUT TO RETAIN FERRULE,LUBRICATING NOTCH CUT IN ID OF SMALL WASHER,WASHERS OVERLAP,BANDED OD |
| ALIGNMENT TYPE | RIGID |
| SURFACE FINISH | GROUND |
| RETAINER FABRICATION METHOD | PRESSED |
| OVERALL HEIGHT | 0.8070 INCHES NOMINAL IN |
| MATERIAL | STEEL OVERALL |