The RIVET,BLIND is a the manufacturer industrial component. Key specifications include material: ALUMINUM ALLOY 2117 OVERALL, head_style: FLUSH (FLAT) COUNTERSUNK (INCLUDED ANGLE - LESS THAN 135 DEG W OR W/O CHAMFER), grip_length: 0.126 INCHES MINIMUM AND 0.187 INCHES MAXIMUM IN, shank_style: PULL THROUGH HOLLOW SHANK, shank_diameter: 0.093 INCHES MINIMUM AND 0.097 INCHES MAXIMUM IN, shear_strength: 70 SINGLE POUNDS PER SQUARE INCH. This part is cataloged in the Federal Logistics Information System under NSN 5320-00-931-8791, indicating validated use in U.S.
government and defense logistics supply chains. Available through authorized enterprise resellers and TPM (Third Party Maintenance) channels. Verify compatibility with your specific system configuration before ordering.
| material | ALUMINUM ALLOY 2117 OVERALL |
| head_style | FLUSH (FLAT) COUNTERSUNK (INCLUDED ANGLE - LESS THAN 135 DEG W OR W/O CHAMFER) |
| grip_length | 0.126 INCHES MINIMUM AND 0.187 INCHES MAXIMUM IN |
| shank_style | PULL THROUGH HOLLOW SHANK |
| shank_diameter | 0.093 INCHES MINIMUM AND 0.097 INCHES MAXIMUM IN |
| shear_strength | 70 SINGLE POUNDS PER SQUARE INCH |
| fastener_length | 0.265 INCHES MAXIMUM IN |
| expansion_device | MANDREL-TYPE C |
| countersink_angle | 99.0 DEGREES MINIMUM AND 101.0 DEGREES MAXIMUM |
| surface_treatment | ANODIZE OR CHROMATE OVERALL |
| head_major_diameter | 0.179 INCHES NOMINAL IN |
| material_document_and_classification | MIL-W-7986 MIL SPEC SINGLE MATERIAL RESPONSE OVERALL |
| NSN | 5320-00-931-8791 |
| HEAD STYLE | FLUSH (FLAT) COUNTERSUNK (INCLUDED ANGLE - LESS THAN 135 DEG W OR W/O CHAMFER) |
| SHANK STYLE | PULL THROUGH HOLLOW SHANK |
| EXPANSION DEVICE | MANDREL-TYPE C |
| SURFACE TREATMENT DOCUMENT AND CLASSIFICATION | MIL-A-8625 MIL SPEC 1ST TREATMENT RESPONSE OR MIL-C-5541 MIL SPEC 2ND TREATMENT RESPONSE OVERALL |
| GRIP LENGTH | 0.126 INCHES MINIMUM AND 0.187 INCHES MAXIMUM IN |
| SHANK DIAMETER | 0.093 INCHES MINIMUM AND 0.097 INCHES MAXIMUM IN |
| HEAD MAJOR DIAMETER | 0.179 INCHES NOMINAL IN |
| FASTENER LENGTH | 0.265 INCHES MAXIMUM IN |
| COUNTERSINK ANGLE | 99.0 DEGREES MINIMUM AND 101.0 DEGREES MAXIMUM |
| SURFACE TREATMENT | ANODIZE OR CHROMATE OVERALL |